![]() ![]() Drill the hole to the specified embedment depth plus minimum hole depth overdrill (see table below) to allow the thread tapping dust to settle, and blow it clean using compressed air. Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed.Simpson Strong-Tie Research and Testing Laboratory at WSU.Simpson Strong-Tie Materials Demonstration Laboratory at Cal Poly.New Product Testing in a Virtual Environment.Outdoor Living: Where Great Backyards Begin.Soft-Story Retrofit for Building Owners.Component Manufacturer Software Solutions.Anchoring Solutions for Value-Added Manufacturing.Cross-Laminated Timber (CLT) & Mass Timber Connector Products.Unreinforced Masonry (URM) Building Retrofit.FX-70® Structural Repair and Protection System
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |